Maytag French Door Ice Maker Not Filling With Water

If the water inlet valve has sufficient pressure and is getting power but the ice maker won t fill with water to make ice replace the water inlet valve.

Maytag french door ice maker not filling with water.

Browse the full line of durable powerful maytag french door refrigerators to find the right model to store and chill food for your family. The water dispenses normally but nothing seems to be getting to the ice machine. Make sure that the water pressure to the valve is at least 20 psi. When ice dispenser is pressed i can hear the ice auger working.

If it cycles but doesn t fill up with water check the fill tube behind the icemaker and if it s frozen solid use a hair dryer and thaw it out. Maytag french door ice maker will not fill with water or make ice. Have had the icemaker water inlet valve inside and the fill valve on back replaced. A refrigerator section may to be too cold.

Ask your own appliance question. The water in the door comes out fine. If the ice maker is on but disconnected to water supply line the following could happen. The ice maker will continue to try to make ice causing a buzzing sound.

If the water pressure is sufficient use a multimeter to check for power to the water inlet valve. If the water inlet valve has sufficient pressure and is getting power but the ice maker won t fill with water to make ice replace the water inlet valve. Repairing an ice maker that isn t receiving water is a process of elimination. Why maytag ice maker wont fill with water.

You can also make sure it s not frozen by disconnect the water line coming from the icemaker and going to the valve at the valve. Water may not be reaching the ice maker due to a frozen line missing filter or a closed supply valve. Verify that the ice maker is turned on. Should be located on a sticker near the ceiling of the refrigerator section and seen if you just open the refrigerator door.

If the ice maker s water supply is not connected to water supply line turn the ice maker off. If the water pressure is sufficient use a multimeter to check for power to the water inlet valve.