Be sure to position your hands above the feather board at all times.
Make a raised panel door with table saw.
Rotate the panel 90 degrees and make a long grain cut.
Sand the saw marks off the surfaces and you ll have a beautiful and easy to make raised panel.
The edge of the panel should slip into the groove in the rails and stiles about 1 8.
Make raised panel doors and drawer faces with your table saw before you begin you need to calculate the door and drawer face sizes.
I did this originally long ago back when i couldn t afford to buy the bit set or the heavier router needed to use them that is normally used to make these doors.
Continue the process on the remaining edges.
You re all set to make the first bevel cut start your saw and feed the panel through pressing it against the fence.
Table saws are great for making rip cuts cross cuts miter cuts and bevel cuts.
When you re done with the first bevel cut clear away the waste piece reclamp the runner and cut the other end of the panel.
The table saw is one of the most versatile tools in a workshop.